Partway through the Bay Dreamin’ boat name, I noticed the dot on the i was missing. The rest of the name was already on the transom, so the dot had to land exactly where it belonged. Here is how we fix a missing vinyl letter like that, using the letters that are already in place to line it up.
Three points to place a missing vinyl letter
We start with a pattern that includes the missing piece along with its neighbors. On Bay Dreamin’, that meant the m, the i and the n around the dot. Then we cut the pattern to the edges of the letters we won’t be using. That way, each edge can sit right on top of the real letter underneath.
Next, we slide the pattern around until those edges match the letters on the boat. You need at least three points of overlap to position it accurately. Two is not enough, so we always look for three or more. This one had six.
Hinging the dot into place
Once the pattern for the missing vinyl letter lines up, we tape it down and hinge it across the top. After that, we trim away the pieces we don’t need, leaving just the dot. Be careful with the scissors here, because the bottom edge can mark the paint. Finally, we lift the hinge, take off the backing and squeegee the dot down. The video below walks through each step.
The same method works on any vinyl lettering
A missing vinyl letter isn’t only a boat name problem. Whether a letter tore, went missing or never made it onto the layout, we can replace a single letter on any vinyl installation by lining it up with the letters around it. As a result, the new piece matches the spacing and angle of the original lettering.
On Bay Dreamin’, the dot is part of the cardinal red Avery outline, which goes on before the Florentine gold leaf. With the missing vinyl letter back where it belongs, the name was ready for the gold.
Our shop is in Edgewater, Maryland, and we can fix a missing letter like this on any vinyl job. For more of our work on the water, browse our gold leaf boat names.
More boat name installations
- Bay Dreamin’: the finished Florentine gold leaf boat name
- Sapphire: a gold boat name across a transom door
- Sonder: a boat name installation from start to finish
- Custom life rings
Contact Designs & Signs
The quickest way to get started on your project is to send us an email.
We can also be reached at (410) 798-5115.



