Pattern taped over the Bay Dreamin' boat name to line up a missing vinyl letter, the dot on the i

Partway through the Bay Dreamin’ boat name, I noticed the dot on the i was missing. The rest of the name was already on the transom, so the dot had to land exactly where it belonged. Here is how we fix a missing vinyl letter like that, using the letters that are already in place to line it up.

Three points to place a missing vinyl letter

We start with a pattern that includes the missing piece along with its neighbors. On Bay Dreamin’, that meant the m, the i and the n around the dot. Then we cut the pattern to the edges of the letters we won’t be using. That way, each edge can sit right on top of the real letter underneath.

Next, we slide the pattern around until those edges match the letters on the boat. You need at least three points of overlap to position it accurately. Two is not enough, so we always look for three or more. This one had six.

Hinging the dot into place

Once the pattern for the missing vinyl letter lines up, we tape it down and hinge it across the top. After that, we trim away the pieces we don’t need, leaving just the dot. Be careful with the scissors here, because the bottom edge can mark the paint. Finally, we lift the hinge, take off the backing and squeegee the dot down. The video below walks through each step.

The dot of the i trimmed out and hinged with tape above the Bay Dreamin' lettering on a dark blue transom

The same method works on any vinyl lettering

A missing vinyl letter isn’t only a boat name problem. Whether a letter tore, went missing or never made it onto the layout, we can replace a single letter on any vinyl installation by lining it up with the letters around it. As a result, the new piece matches the spacing and angle of the original lettering.

On Bay Dreamin’, the dot is part of the cardinal red Avery outline, which goes on before the Florentine gold leaf. With the missing vinyl letter back where it belongs, the name was ready for the gold.

Red Avery vinyl dot back in place on the i of the Bay Dreamin' boat name

Our shop is in Edgewater, Maryland, and we can fix a missing letter like this on any vinyl job. For more of our work on the water, browse our gold leaf boat names.

More boat name installations

Contact Designs & Signs

The quickest way to get started on your project is to send us an email.
We can also be reached at (410) 798-5115.

Let's Get Started!

We've been making signs by hand since 1976, from gold leaf boat names and carved quarterboards to dimensional letters and glass gilding.

The quickest way to begin is to send us a message with your project details, and we'll get back to you with ideas and pricing.

We look forward to working with you!

Call Us

Send Us a Message